| General specifications |
| Signal type | Analog input |
| Functional safety related parameters |
| Safety Integrity Level (SIL) | SIL 2 |
| Supply |
| Connection | terminals 14 , 15- or power feed module/Power Rail |
| Rated voltage | 20 ... 30 V DC |
| Ripple | within the supply tolerance |
| Power dissipation/power consumption | ≤ 1.53 W / 1.53 W |
| Interface |
| Programming interface | programming socket |
| Input |
| Connection side | field side |
| Connection | terminals 1, 2, 3; 4, 5, 6 |
| RTD | type Pt10, Pt50, Pt100, Pt500, Pt1000 (EN 60751: 1995) type Pt10GOST, Pt50GOST, Pt100GOST, Pt500GOST, Pt1000GOST (6651-94)
type Cu10, Cu50, Cu100 (P50353-92)
type Ni100 (DIN 43760) |
| | Measuring current | approx. 200 ?A with RTD |
| | Types of measuring | 2-, 3-wire connection |
| | Lead resistance | max. 50 Ω per line |
| | Measurement loop monitoring | sensor breakage, sensor short-circuit |
| Thermocouples | type B, E, J, K, N, R, S, T (IEC 584-1: 1995)
type L (DIN 43710: 1985)
type TXK, TXKH, TXA (P8.585-2001) |
| | Cold junction compensation | external and internal |
| | Measurement loop monitoring | sensor breakage |
| Potentiometer | 0 ... 20 kΩ (2-wire connection), 0.8 ... 20 kΩ (3-wire connection) |
| Voltage | selectable within the range -100 ... 100 mV |
| Input resistance | ≥ 1 MΩ (-100 ... 100 mV) |
| Output |
| Connection side | control side |
| Connection | output I: terminal 7: source (-), sink ( ), terminal 8: source ( ), terminal 9: sink(-)
output II: terminal 10: source (-), sink ( ), terminal 11: source ( ), terminal 12: sink(-) |
| Output I, II | Analog current output |
| | Current range | 0 ... 20 mA or 4 ... 20 mA |
| | Fault signal | downscale 0 or 2 mA, upscale 21.5 mA (acc. NAMUR NE43) |
| | Source | load 0 ... 550 Ω
open-circuit voltage ≤ 18 V |
| | Sink | Voltage across terminals 5 ... 30 V. If the current is supplied from a source > 16.5 V,
series resistance of ≥ (V - 16.5)/0.0215 Ω is needed, where V is the source voltage.
The maximum value of the resistance is (V - 5)/0.0215 Ω. |