1、 注意保存，保存条件不好时，会降低膜片与反射壳（导光板）的粘附力。推荐保存条件为：温度25℃±10℃ 温度65℃±20℃
Store with care. Storing the units in bad conditions will cause the reflector sheet and decrease it’s Adhesive power. Storage the products under the Conditjon:temperature (25℃±10℃) and humidity(65℃±20℃ORH) our recommendation.
2、 焊接温度260℃±5℃，焊接时间小于3秒，烙铁功率小于30W。
The Soldering tempwrature is260℃±5℃and Soldering Time should be less than 3 sec, and soldering iron power should be less than 30W.
3、 焊接点应离产品实体大于1.6mm.
The soldering point should be farther than 1.6mm form body.
4、注意防静电，戴有绳腕带，工作台上要有防静电垫，设备、仪器要可靠接地，电烙铁、锡炉、波峰焊要可靠接地。